Field Value Check

Only available for "Activation by data change"

This setting allows defining values, which must be tested if a control group is activated. It is necessary that the field entries must match the settings; else an error message will appear. Please refer also to ProMaterialData, User Manual, Application.

If the field value check will be activated depends on the settings according to Activation, Field value check.
Always current (and therefore the eventually changed) values will be checked. More than one filter for same field will be linked OR, e.g. one value must be set.
Characteristics allowing multiple values can NOT be used, see Filter Definition.
If the option "Signal as warning" is selected, then a message from a negative check can be ignored by the user and the data be saved. But only if no other condition without activated option "Signal as warning" is checked negative.

The general description of the fields and their usage according to the Filter Definition applies.