Checking target and applying to SAP Structures

Two functions are available for checking the target structure and data and for applying the ProStructure internal target structure to the SAP structures:

Checking the defined target structure

Makes a new structure comparison and various consistency checks on the target structure.

No SAP structure data is changed.
The messages are displayed in the "Validation message" Widget
These messages are not saved.

Apply changes to target structure

Only available if all structure changes have been saved, see Change Mode and Safe.
Checks the structure as described above in Checking the defined target structure.
If the check is successful (no errors), the changes are applied to the SAP structures.
Messages are output in the "Messages from last synchronization" Widget of the last adjustment.
These messages are saved and are available again when the corresponding structure relationship is reloaded.

Push button	Action

Push button	Action
	Verify the defined target structure
	Apply changes to target structure

Note that applying the changes to the data structure, any changed data from the SAP structures will be synchronised with the SMC internal structures when structure relation is reopened after saving. The 'Save' function could therefore be active again.

Data to be synchronised can be any data changes from SAP or customer specific code and due to changes to SAP internal item identifiers.